Operation Manual

If your TV does not have optical:
Use the included analogue cable to connect the audio output from your
TV to the airSOUND BASE AUX 1 or AUX 2 inputs. You will need to
change the source of the airSOUND BASE to AUX to hear this input.
Note: Some TVs may only have a 3.5mm jack (headphones) output,
you can also use this output. If your TV has no audio output, you can
connect the optical cable to your set top box.
Remote control
Source Changes the input source
Volume + / - Controls volume
Power Enter standby / resume
Treble + / - Changes the sound of the airSOUND BASE + / - 5 steps.
Bass + / - Changes the volume of the subwoofer + / - 5 steps.
Mute Enables mute / resumes playback
Note: When a remote control button is pressed and the airSOUND BASE
responds, the status LED will flash.
Sound Source / Setting memory
When the power is connected, the sound and source of the airSOUND
BASE is reset. The inputs are:
1. Optical (default)
2. AUX 1 (RCA inputs)
3. AUX 2 (jack input)
Note, the volume, bass, treble and source settings are remembered
when entering or resuming from standby.
FRONT GRILLE
The airSOUND BASE front grille is easily changed. It is held in place by
magnetic attachments. To replace the front grille, gently pull the side of
the grille away from the unit, and it will detach. Oer the new grille, and
it will snap into place.