User Manual

7.
6.
Get Familiar with
OrCam MyEye.
Power Button.
- The power button is a recessed button on the inner side of the device,
opposite the touch bar.
- The power button enables you to do the following:
Turn on your OrCam MyEye.
1. Press the power button for about 2 seconds. Once you hear the beep
you may let go of
the power button.
2. While the device is powering on you will hear a series of beeps.
3. The LED light near the touch bar will turn orange and then blue as the
device wakes up,
and will remain blue upon fully awakening.
4. After about one minute you will hear a chime and then, “OrCam MyEye
Version [xx] is
ready. Battery is [xx] percent charged”.
Note: If you did not hear the phrase, “OrCam MyEye is ready”, or you are
not sure that OrCam MyEye is powered on, touch the touch bar. If the
device is powered on, you will hear an audio response.
Turn off your OrCam MyEye.
1. Press the power button once. You will hear a beep and, “Suspending.
Press again to
shut down.”
2. Press the power button again. You will hear a beep and, “Shutting down,
please wait”.
3. Just before the device shuts down, you will hear, “Power off. Bye bye”.