Use and Care Manual
Ore Vaults
®
Installation Instructions
!
!
NOTE: The finish grade of the surrounding area
must drain water away from the installation.
• Set the Ore Vault unit towards the front edge
of the mounting pad so that the brick does not
exceed the pad, then brick in place as desired.
• Mortar must not extend out past the front
outside edge of the exterior housing.
MOUNTING CURB
• Bricks should not extend more than 1” out from
the front edge of the unit. (As shown below)
• The mortar thickness between the unit wrap and the
bricks on each side should be at least 1/2” thick.
!
Exhibit A