75691-02 REV A S I M P L Y A M A Z I N G® B USER’S GUIDE 2635RH HIGH SPEED UPRIGHT VACUUM CLEANER WITH ® CLEANING SYSTEM •IMPORTANT• SAVE THIS BOOKLET! Includes: • Safety Warnings • Warranty • Operating Instructions • Trouble Diagnosis • Accessories
IMPORTANT SAFETY INSTRUCTIONS BEFORE OPERATING CLEANER, READ ALL INSTRUCTIONS IN THIS MANUAL CAREFULLY. When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER WARNING To reduce the risk of fire, electric shock, or injury: Table of Contents Plug Fitting Instructions, Important Safety Instructions . . . . . . . page Maintenance and Customer Service, Warranty, and Accessories . . . . . . . .
Maintenance and Customer Service ACCESSORIES ITEM Your ORECK vacuum cleaner is a product of precise engineering. The motor bearings are permanently lubricated and should not be oiled. If you require additional information or have problems with your ORECK appliance, or to order new bags or spare parts, you may call ORECK customer service at: 1. 0845 603 0153 Or write to: Oreck UK P.O.
To Replace Filter Dust Bag Assembly To assist you in identifying components of your vacuum, the parts have been numbered as follows: 1 Handle tube, upper 2 Tube, lower 3 Power head 4 Outer bag 5 Paper filter dust bag 5 6 Power cord 7 Retaining spring 8 Bag tension bar 9 Zip fastener 10 On/off switch 11 Cord hook 12 Plastic loop/cable clamp 13 Connector assembly 14 Fan housing 15 Cord assembly 1 WARNING: Unplug cord from electrical outlet before servicing. 10 11 BAG REMOVAL: 1.
Operating Instructions To Operate Make sure the disposable paper filter dust bag is in place. DO NOT operate the cleaner without a paper filter dust bag. Plug the power cord into an electrical outlet. Press the ON(l) OFF(O) switch on handle assembly when ready to operate. All paper dust bags are not the same. Your ORECK disposable dust bags have been designed to be used with the ORECK cleaner.
How to Replace a Worn Belt To Adjust or Replace Brush WARNING: Unplug cord from electrical outlet before servicing. WARNING: Unplug cord from electrical outlet before servicing. Remove the replacement belt from the storage channel. To determine if the brush is worn, place a firm straight edge across the nozzle opening. If brush bristles do not extend beyond baseplate, brush should be adjusted. Remove the baseplate by removing 5 screws. Then, remove the belt and brush roll from the housing.
5. Many times blockage occurs due to a full dust bag causing dirt to back down the air flow system. When that happens, the blockage will be at the top of the system, starting in the area where the dust bag connects to the connector assembly. See illustration F. Stuffing or Blockage Under certain conditions it is possible to stuff or block the intake tube and the lower tube assembly.
Troubleshooting Guide WARNING: Unplug cord from electrical outlet before servicing. SAVE SERVICE CALLS...
