S I M P L Y A M A Z I N G ® USER’S GUIDE TRAVEL IRON/STEAMER MODEL JP777 •IMPORTANT• SAVE THIS BOOKLET! USA: 1-800-989-3535 CANADA: 1-888-676-7325 WWW.ORECK.COM VISIT ONE OF OUR OVER 750 LOCATIONS Includes: Important Safety Instructions Warranty Operating Instructions REGISTER YOUR PRODUCT ON THE WEB: WWW.ORECK.
IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE WARNING To reduce the risk of fire, electric shock, or injury: • Use the Travel Iron/Steamer only for its intended use. • This appliance is provided with a voltage selector, it can be used on 120 V/230 V main power. This appliance will be set at the factory at 120 volts.
IMPORTANT SAFETY INSTRUCTIONS CONTINUED When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE WARNING To reduce the risk of fire, electric shock, or injury: • Never switch the dual voltage selector while the appliance is in use. • This appliance was set at the factory to operate at 120 volts. Refer to the General Information section of this manual for conversion to 230 volt operation.
Assembly To assist you in identifying components of your Travel Iron/Steamer, the parts have been numbered as follows: 1. Steam Burst Button 2. Cord Protector/Power Cord 3 4 5 6 7 8 9 10 11 12 13 14 2 3. Water Tank Release Button 4. Water Tank Lid 5. Detachable Handle Cover/Water Tank 1 6. Handle Base 7. Temperature Indication Point 8. LED Light 9. Temperature Control Knob 10. Voltage Selector 11. Housing 17 12. Handle Release Button 15 13. Base Plate 14. Soleplate 15.
General Information Continued Filling with Water 1. Lift handle into position. Gently press the water tank release button located at the end of the water tank and remove the detachable handle cover/water tank (Fig. B). 2. Lift up the water tank plug and fill with water. Do not overfill. To close the water tank plug, press it down firmly then replace the water tank back in the original position (press firmly until you hear a “click” sound). (Fig.
Using as a Dry Iron This iron can also be used without steam as a Dry Iron even if there is water inside the water tank. 1. Unwrap the cord and plug the unit into a wall outlet. Set the temperature control knob to the desired setting. 2. The LED light will illuminate. When the LED light goes out, it means the iron reached the working temperature and it can be used as a Dry Iron.
3 Cleaning & Storing Instructions 4 2 5 6 1. After use, unplug the Iron/Steamer and allow it7to cool down. 8 2. Once the appliance has cooled, press the water 9 tank release 1 10 tank. button and remove the detachable handle/water 3. Lift up the water tank plug and empty the water11in the water 12 tank. Replace all parts to their original positions. 13 4. Allow the appliance to cool down completely before 14 cleaning. TO CARE, CLEAN AND STORE 5.
