75702-02 REV B S I M P L Y A M A Z I N G® B USER’S GUIDE USA: 1-800-989-3535 CANADA: 1-888-676-7325 COMMERCIAL: 1-800-242-1378 www.oreck.com www.oreckcommercial.
IMPORTANT SAFETY INSTRUCTIONS BEFORE OPERATING CLEANER, READ ALL INSTRUCTIONS IN THIS MANUAL CAREFULLY. When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER WARNING Table of Contents Maintenance and Customer Service, Important Safety Instructions, Accessories . . . . . . . page Warranty, Troubleshooting Guide . . . . . . . . . . . page Assembly, Operating Instructions . . . . . . . . . . . .
Warranty Troubleshooting Guide ORECK MANUFACTURING COMPANY: (Oreck Manufacturing Company gives you the following limited warranty for this product only if it was originally purchased for residential use, not resale, from Oreck or an Oreck Authorized Retail Dealer.) WARNING: Unplug cord from electrical outlet before servicing. SAVE SERVICE CALLS...
Operating Instructions Assembly To assist you in identifying components of your vacuum, the parts have been numbered as follows: 1 Handle section, upper 2 Tube, lower 3 Power head 4 Outer bag 5 Paper filter dust bag 5 6 Power cord 7 Retaining spring 8 Bag tension bar 9 Zip fastener 10 On/off switch 11 Cord hook 12 Connector assembly 13 Fan housing To Operate 9 Make sure disposable paper filter dust bag is in place. DO NOT operate the cleaner without a paper filter dust bag.
All paper dust bags are not the same. Your ORECK disposable dust bags have been designed to be used with the ORECK cleaner. Using bags other than genuine ORECK TYPE CC disposable bags will affect the cleaning ability of your cleaner and could cause damage to it. To Replace Filter Dust Bag WARNING: Unplug cord from electrical outlet before servicing. The Belt The belt on your vacuum cleaner controls the speed of the revolving brush and is very important for the effective operation of the cleaner.
How to Replace a Worn Belt Stuffing or Blockage WARNING: Unplug cord from electrical outlet before servicing. Under certain conditions it is possible to stuff or block the intake tube and the lower tube assembly. If your vacuum cleaner does not pick up properly, or makes unusual noise and the outer bag does not fluff up or balloon open, follow the following steps: Remove the replacement belt from the storage channel. WARNING: Unplug cord from electrical outlet before servicing.
5. Many times blockage occurs due to a full dust bag causing dirt to back down the air flow system. When that happens, the blockage will be at the top of the system, starting in the area where the dust bag connects to the connector assembly. See illustration F. To Adjust or Replace Brush F Connector Deflector Opening WARNING: Unplug cord from electrical outlet before servicing. To determine if the brush is worn, place a firm straight edge across the nozzle opening.
75702-02 REV B 05/05 ECN# R-8018 ©2005 Oreck Holdings, LLC. All rights reserved. All word marks, logos, product configurations, and registered trademarks are owned and used under the authority of Oreck Holdings, LLC.
