75726-01 REV A S I M P L Y A M A Z I N G® USER’S GUIDE U2510RH U2520RH U2530RH USA: 1-800-989-3535 CANADA: 1-888-676-7325 COMMERCIAL: 1-800-242-1378 www.oreck.com www.oreckcommercial.
BEFORE OPERATING CLEANER, READ ALL INSTRUCTIONS IN THIS MANUAL CAREFULLY. IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be followed, including the following: Table of Contents READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER Maintenance and Customer Service, Polarized Plug Notice, Accessories, Important Safety Instructions . . . . . . . . . . . . . . . page 2 Warranty, Troubleshooting Guide . . . . . . . . . . . . . . . . . . . . . . .
Warranty Troubleshooting Guide WARNING: Unplug cord from electrical outlet before servicing. ORECK MANUFACTURING COMPANY: (Oreck Manufacturing Company gives you the following limited warranty for this product only if it was originally purchased for residential use, not resale, from Oreck or an Oreck Authorized Retail Dealer.) SAVE SERVICE CALLS...
1 2 3 4 5 8 9 10 Upper Handle Connector Assembly 6 7 ENFONCEZ JUSQU’À JUSQU’À ENTENDRE UN BRUIT PRESIONE HAST A HASTA ESCUCHAR UN CHASQUIDO DE SUJECI SUJECIÓ ÓN SUJECIÓN 11 12 13 14 16 17 18 19 15 20 OLD NEW 21 23 22 24 25 Fan Housing Retainer Spring ç ç O-ring Intake Opening Intake Opening 27 26 Fan Housing 28 Connector Deflector Opening 4 Tube
Parts List 4. Although your upright will pick up pins, paper clips, and other small objects, it is recommended that these be removed from the floor before you vacuum. Failure to do so may result in permanent damage to the motor suction fan and its housing. To assist you in identifying components of your vacuum, the parts have been numbered as follows: 5. WARNING: Do not use your vacuum cleaner on damp or wet surfaces. This will cause damage to the vacuum cleaner and is dangerous to the user.
CAUTION—Wood Floors, Soft (Vinyl, Asphalt Tile, etc.) Floor Surfaces and Polished Floor Finishes IMPORTANT: Unless the brush is worn as indicated above, both bearings must be in the “NEW” position. When rotating, both bearings must be in the “OLD” position. Unmatched settings will cause damage to your machine. Use floor and floor finish manufacturer’s recommended methods of cleaning.
©2005 Oreck Holdings, LLC. All rights reserved. All word marks, logos, product configurations, and registered trademarks are owned and used under the authority of Oreck Holdings, LLC.