75724-01 REV A S I M P L Y A M A Z I N G ® B USER’S GUIDE XL5-105HH HIGH SPEED UPRIGHT VACUUM CLEANER WITH ® CLEANING SYSTEM •IMPORTANT• SAVE THIS BOOKLET! Includes: • Safety Warnings • Warranty • Operating Instructions • Trouble Diagnosis • Accessories
1 Upper Handle 2 3 4 5 8 9 10 Connector Assembly 6 7 PRESS UNTIL SNAP IS HEARD ENFONCEZ JUSQU’À ENTENDREUNBRUIT PRESIONEHASTA ESCUHARUN CHASQUIDODESUJECI 11 12 13 14 16 17 18 19 15 20 OLD NEW 21 22 23 24 25 Retainer Spring Ressort de retenue Resorte retenedor Intake Opening Ouverture d’admission Abertura de admisión 26 Tube Tubo 27 Fan Housing Boîtier du ventilateur Bastidor del ventilador O-ring Anneau torique Anillo tórico Intake Opening Ouverture d’admission Abertura
BEFORE OPERATING CLEANER, READ ALL INSTRUCTIONS IN THIS MANUAL CAREFULLY. IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be followed, including the following: Table of Contents Maintenance and Customer Service, Plug Fitting Instructions, Accessories, Important Safety Instructions . . . . . . . . . . . . . . . page 2 Warranty, Troubleshooting Guide . . . . . . . . . . . . . . . . . . . . . . .
Warranty Troubleshooting Guide WARNING: Unplug cord from electrical outlet before servicing. ORECK MANUFACTURING COMPANY: (Oreck 21180 Johnson Road; Long Beach, MS, USA 39560 gives you the following warranty for this product only if it was originally purchased for residential use, not resale from Oreck or an Oreck Authorized Retail Dealer.) SAVE SERVICE CALLS...
Parts List 3. If at any time the machine does not pick up properly or makes an unusual noise, STOP OPERATION and service. 4. Although your upright will pick up pins, paper clips, and other small objects, it is recommended that these be removed from the floor before you vacuum. Failure to do so may result in permanent damage to the motor suction fan and its housing.
fig. 19 Rotate both bearing assemblies at ends of brush roll to show "OLD" and replace in the holding channels in the housing. NOTE: The bearing assembly setting marked "OLD" has no ribs on the top of the assembly. The one marked "NEW" has several ribs. When rotating bearings, make sure both bearing assembly settings are the same and face up when replacing the brush roll. fig. 16 Reassemble the belt and the baseplate and check bristle height above baseplate at each end of brush.
fig. 29 Many times blockage occurs due to a full dust bag causing dirt to back down the air flow system. When that happens, the blockage will be at the top of the system, starting in the area where the dust bag connects to the connector assembly. NOTE: If the above actions do not correct the problem, contact an Oreck Authorized Service Center or call the customer service center at: 0845 603 0153.
© 2005 Oreck Holdings, LLC. All rights reserved. All word marks, logos, product configurations, and registered trademarks are owned and used under the authority of Oreck 75724-01 REV A Holdings, LLC. Printed in America.