Operation Manual

EN
8
ICON MEANING
Searching for sensor
Sensor found
No Sensor
Press SEARCH to manually activate a search for the
radio-controlled clock signal. The reception icon will blink
until the clock signal is found or the search period times
out.
NOTE Signals from household devices such as
doorbells, electronic garage doors, and home security
systems may cause temporary reception failure. This
is normal and does not affect general product
performance. The reception will resume once the
interference ends.
CLOCK
This product tracks the time and date based on radio-
controlled signals from the RTGR328N remote sensor,
or manual settings that you enter.
STRONG SIGNAL WEAK SIGNAL NO SIGNAL
RADIO-CONTROLLED CLOCK
The time and date are automatically updated by radio-
controlled clock signals from official time-keeping
organizations in Frankfurt (Germany) and Rugby
(England) unless you disable this feature. The signals
are collected by the remote sensor (RTGR328N)
whenever it is within 1500 km (932 miles) of a signal.
MAIN UNIT SENSOR SEARCHING
Initial reception takes 2-10 minutes, and is initiated when
you first set up the unit, and whenever you press
RESET. Press and hold TEMP / HYGRO SEARCH for
2 seconds to manually activate sensor searching. Once
complete, the reception icon will stop blinking.
To view the status of the main unit’s signal with the
outdoor temperature and humidity channel(s), go to the
TEMP & HUMIDITY Display:
AWS899_EN_R13 3/7/05, 5:36 PM8