Operation Manual

4
Features of this Product
OREGON SCIENTIFIC Dermalift Pro - Introduction
This beauty care device employs radio frequency (RF) thermal
technology for high frequency thermal skin care, together
with EMS to treat facial muscles.
There are 4 RF output heads, providing RF waves at one million
vibrations per second, as well as an EMS output head for
alternating low frequency electric current. Thermal treatment
and muscle stimulation may be carried out simultaneously.
Temperature sensor (Thermostat) is used to gauge the
temperature, protecting the skin and ensuring its gentle
warming with temperatures maintained at approximately 40
o
C.
EMS
A method to strengthen and stimulate muscles through
the use of electric impulses. Widely used in muscles
training and general exercising equipment.
Radio Frequency (RF) Thermal Technology
Skin is warmed up through high frequency vibrations.
Widely used in thermal beauty treatments.
Operating Procedures
1. Charge the device
2. Cleansing of face (body)
3. Apply sonic aqua gel on area to be
treated
4. Power on the Dermalift Pro
5. Select Treatment Mode
6. Select Power Level (For face: Not
exceeding 2)
7. Place the Dermalift Pro on area to
be treated, following the procedures
described in “Treatment” on P.20 – P.23,
slowly glide the device in the direction
indicated by the arrows.
8. End the treatment procedure for each
part after 3 minutes.
9. Clean the device
10. Put the device in storage
**You must apply EMS applicable sonic aqua gel when using the DermLift Pro.
The gel can be purchased at Oregon Scientific HK shop or HK e-Shop (www.oregonscientific.com.hk)
RF Output Head
EMS Output Head
Temperature Sensor
(Thermostat)