Operation Manual

When the unit is in charging stage, the battery icon keeps changing,

increasing from one segment to two segments and then three segments

(full) continuous until it is fully charged. After the unit is fully charged,

the full battery icon is displayed.

NOTE: Charging only begins after the computer has been turned on.

When the battery is fully charged, the battery icon shows and will blink

slowly. The battery status indicators are as follows:

Medium

Low Full

NOTE: When the battery icon shows, this indicates the battery is about

to run out of power within a few minutes. Recharge the battery as

soon as possible.

IMPORTANT: It is important to slide the "ON / OFF" switch on the

back of the MP3 player to "OFF" when the unit is not in use. (This

prevents the MP3 player from using all it's power).

CHARGING WITH THE AC ADAPTOR

Connect the AC power adaptor supplied with the player to the USB connector

of the player. The AC cable and plugs differ from region to region.

NOTE: The charging time is approx. 3 hours.

POWER ON / OFF

POWER ON

To turn on your MP3 player:

1. Press and hold the MENU / ON button for 2 seconds.

The Oregon Scientific "splash screen" will

appear to indicate system software is loading

from the hard disk drive. When the unit is fully

powered on (all system software loaded and

active), the unit will display the Main Menu.

MP303 Eng r10 OP 9/16/04, 5:47 AM7