Operation Manual

To tune a channel:

1. In the "Radio" mode, press the / OFF button to set the screen

in the "Tune" mode. (If the screen says "Preset" then you will

need to press the key twice).

2. Then use the button to move up or down. (The FM band number

will increase or decrease as you move the key. Simply tune until

you find a clear channel you want to listen to).

NOTE: FM scanning reception may vary in different areas.

To exit the Radio mode:

Simply press the

or MENU / ON button. (You will return to the Main

Menu).

The display in the Radio mode, you will see:

1. Button hold indicator

2. Battery status indicator

3. Frequency display (e.g. 102.35MHz)

4. Information display

RECORD MODE

Prior to initiating Voice Recording, the user must verify the record option

in the Settings Menu.

To verify the record settings:

1. From the Main Menu, select the "Settings" Menu option.

2. Using the

button, scroll down until you highlight the "Record

Settings" sub-menu option. Press the

or MENU / ON button

to display this menu.

3. For the "Source" option, press the

or MENU / ON button to

switch between the various recording sources. (The default

setting is "Microphone," which is used for voice recording. Another

option is "FM" for recording from the FM radio).

4. After selecting "Microphone" as the source, use the

to scroll

down to the data rate. (The recommended data rate for voice

recording is 8000HZ, as this creates acceptable quality and

small files sizes).

MP303 Eng r10 OP 9/16/04, 5:47 AM16