Operation Manual

EN
7
• Never immerse the product in water. This can cause
electrical shock and damage the product.
• Do not subject the product to extreme force, shock,
or fluctuations in temperature or humidity.
• Do not tamper with the internal components.
• Do not mix new and old batteries or batteries of
different types.
• Do not use rechargeable batteries with this
product.
• Remove the batteries if storing this product for a long
period of time.
• Do not scratch the LCD display.
• Placement of this product on wood surfaces with
certain types of finishes, such as clear varnish, may
result in damage to the
finish. Cons
ult the furniture
manufacturer’s care instructions for direction as to
the types of objects that may safely be placed on
the wood surface. Oregon Scientific shall not be
responsible for any damage to wood surfaces from
contact with this product.
• Do not dispose this product as unsorted municipal
waste. Collection of such waste separately for
special treatment is necessary.
NOTE
The technical specification of this product and
The technical specification of this product and
contents of this user manual are subject to change
without notice. Images not drawn to scale.
• Press any key except to mute any
alarm and activate it again in 24 hours.
PROJECTION UNIT
The projection unit can display both time and alarm
status. To use this feature:
• Slide the
switch
ON
to activate
continuous projection. However, this function will
not work unless the AC / DC
adapter
is used.
adapter is used.adapter
NOTE
You can also press the
You can also press the
button
to project the time and alarm status for 5 seconds.
RESET THE CLOCK
To reset the unit, insert a thin blunt instrument into the
reset hole.
WARNINGS
This product is designed to give you years of service
if handled properly. Oregon Scientific will not be
responsible for any deviations in the usage of the
device from those specified in the user instructions or
any unapproved alterations or repairs of the product.
Observe the following guidelines:
• Do not clean any part of the product with benzene,
thinner or other solvent chemicals – this may cause
permanent damage that is not covered by the
guarantee. When necessary, clean it with a damp
cloth.
RRM313P_M_EN_op.indd 7 2006.4.6 3:19:52 PM