Operation Manual

10
ENG
Note: The handset number will display after the assigned name. For example, if
you named handset 2 “Sally”, it will appear as “Sally 2”. The number cannot
be changed.
Tip: To return to standby mode, press and hold the
button.
Charging the handset batteries
The batteries may take up to 15 hours to fully charge the first time you use
them.
The battery icon on the handset display becomes progressively empty as the
batteries become low. When the batteries are fully charged, the icon looks full
and dark, as shown here
. When the icon appears empty as shown here
or if you hear the warning beep during a call, please:
• End the call as soon as possible.
• Don’t use the speakerphone mode since this consumes more energy than
the normal talk mode.
• Put the handset back on the charger for charging until the battery icon
returns to high level.
To charge the handset, put it in the charger with the keypad facing outwards. The
blue CHARGE light steadily lights to indicate that the handset is charging. When
the battery indicator appears full, and the charge light goes off, the batteries are
fully charged.
Replacing the batteries
Rechargeable batteries may need to be replaced from time to time. If you find
that you can no longer recharge the batteries, replace them with two new
batteries of the same size (AAA) and type (rechargeable Ni-MH) following the
instructions on page 6.
Attaching the belt clip
To attach the belt clip to the back of the handset:
1. Slide the belt clip over the back of the handset until the ventilation holes .
are aligned.
2. Gently push the belt clip until it clicks into place.
USING THE HANDSET
Before you start
When you first set up your handset, you may hear an out of range beeping tone
and see the words Base 1 flashing on the handset display area. This is normal,
and means that the handset needs to synchronize with the base unit before you
can use it. Hold the handset near the base unit for a few seconds until the
handset display stops flashing.