Operation Manual

31
ENG
• You may have already registered 5 handsets to the base unit. If so, you will need
to remove one or add another base unit before you can register the new handset.
• If you are replacing a faulty handset, make sure you have fully removed the
faulty one before registering the new one. Refer to the instructions on page 16
for more information.
• If you are still experiencing problems, you may need to reset all the registrations,
then start over. Refer to page 7 for instructions.
“I cannot make a call.”
Only one outside call and one intercom call can take place at the same time. Make
sure no one else is already using the phone; if so, you will see the EXT symbol on
the handset display area, and will hear the busy tone when you try to place a call.
Problems with programming
“I changed the PIN, and I’ve forgotten the new one.”
Please refer to page 19 for instructions on resetting the PIN number.
“I tried to register a new handset, and now all the handsets are flashing “Base”
and I can not use the telephone.”
Reset your telephone, then try the registration process again. If you are still
experiencing problems, reset all your handsets and base units following the instruc-
tions on page 9, then re-register the handsets.
ADDITIONAL RESOURCES
Visit our website to learn more about your ThermoDECT telephone and other
Oregon Scientific products such as additional handsets and base units. Contact
information for our team of customer service representatives is on the website.
Website: www.oregonscientific.com