Operation Manual

8
ENG
4. Press to select Remove HS from the options.
5.Press
.
6. Enter the security PIN for the handset. The default PIN code is “0000”. For
more information about security PIN codes, refer to page 19.
7.Press
.
8. Press
or until the number for the handset you wish to remove is
highlighted.
Tip: The handset number is shown on the display when it is in standby mode.
Note: You cannot remove the handset that you are using.
9.Press
.
10. Press
again to confirm your selection.
Setting a default base unit (multiple base units only)
If you cross-register your handset with more than one base unit, you can choose
which base unit the phone will connect with when making or receiving calls. The
default setting is for each handset to connect through the first base station it
finds within range. However, if you wish to specify a particular base unit for a
handset, you can change the setting using the instructions below.
To set a default base unit for a handset:
1. Press the
button.
2. Press
to select Setup from the options.
3. Press .
4. Press
to select Base from the options.
5. Press to display the number of handsets registered with the current
base.
6. Press
or to select the base unit with which you wish to associate the
handset.
• To choose a specific base unit, place a mark [
] next to the number that
corresponds to the base unit through which you wish to connect. For
example, if you wish to connect the handset through Base Unit 2, place a
mark [
] next to 2.
• To auto-select the first base unit within range, select Automatic.
7. Press
to confirm your selection.
Tip: To return to standby mode, press and hold the
button.