Use and Care Manual

SAW CHAIN

Saw Chain Maintenance

How to Install New Saw Chain Parts

Read operation and handling warnings on page 34.

Note: Use only OREGON® parts to repair OREGON® saw chain,

and only use parts which are the correct size and type for your

saw chain.

1. Remove rivets, and parts to be replaced, as shown under “How to

Break Out Rivets,” pages 46 – 47. Never reassemble a saw chain with

old preset tie straps — always use new preset tie straps.

2. If needed, file off bottom of new parts to match existing worn

parts. File new cutters back to match worn cutters. Do not file the

tops of kickback-reducing bumper tie straps or bumper drive links.

3. Place the preset tie strap on a flat outer

surface of a saw chain breaker anvil. Be sure

the rivets are pointing up.

18HX 18HX 18HX 18HX