Big button phone TP58 User Guide
1 General Information Warnings Do not use your telephone during an electrical storm thunderstorm as it is possible to get an electric shock. Refer to information contained in Telstra White pages directory. The earpiece of the handset may attract small metal objects such as staples and pins. Care should be taken when placing the handset near these items.
2 Location of controls 7 8 1 9 10 RECEIV LO MID ER HI 2 3 123 456 789 0# STORE 4 5 6 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14.
3 Installation 3.1 Check contents of pack The following items are supplied in this pack: one telephone base one telephone handset one short telephone cable one curly cord one long telephone cable one operating Manual one warranty card 3.2 Connect the handset and line cord Connect the telephone handset to the base unit. Plug one end of the curly cord into the socket on the handset. Locate the socket on the base of the phone and plug the other end of the curly cord into this.
NOTE! There is a small hanging device in the handset rest to prevent the handset from falling from the rest when the telephone is mounted on the wall. You can hang the handset on the telephone without hanging up. Use the small hanging device for this purpose at the upper end of the handset rest. 3.4 Adjustable ringer volume You can use the RINGER OFF/LO/HI slide switch located on the back of the telephone to select the incoming ring volume. Should you not want to be disturbed, use select OFF position. 3.
Receiving a Call When you receive a call, the phone rings and the Visual ringer light flashes. To answer the call, lift the handset or press SPEAKER button (SPEAKER LED turns on). Replace the handset or press SPEAKER button (SPEAKER LED turns off) to end the call. NOTE! If you want to change during a call from the handset to the speakerphone, press the SPEAKER button and replace the handset. If you want to change from the speakerphone to the handset, simply lift the handset. 4.
5 Storing telephone numbers You can store 6 numbers under the one touch buttons (M1M6). 5.1 Saving numbers 1. 2. 3. 4. 5. 6. Lift the handset listen for dial tone. Press the STORE button. Enter the required telephone number using the number pad. Press the STORE button. Now press one of the six one touch dial buttons (M1-M6). Replace the handset. Tips on storing numbers: Storage locations that have already been used cannot be erased. Simply save a new number in the storage location that you want to erase.
6 Important information Troubleshooting If you feel this product is not working correctly please consult the user guide and ensure that you are using the product in accordance with the instructions. Remove all extra telephone equipment and connect only this telephone directly to the telephone socket. If the fault is still present, connect another telephone (if available) to the telephone socket. The results will show you whether the fault lies with this product or with the telephone line.
Warranty Information This product is covered by a 12 month warranty against defective workmanship or parts, effective from the date of purchase. The warranty does not extend to damage caused by misuse, negligence, excessive voltage, faults on the telephone line or lightning. This warranty in no way affects your statutory rights. Full details of the warranty are contained in the enclosed warranty card.
Australia New Zealand Oricom International Pty Ltd Locked Bag 658 South Windsor NSW 2756 Atlas Gentech (NZ) Ltd, Private Bag 14927, Panmure, Auckland Customer support Email: support@oricom.com.au Web: www.oricom.com.au Fax: (02) 4574 8898 Ph: 1300 889 785 Customer Support Email: support@atlasgentech.co.