Instruction Manual

ASSEMBLY INSTRUCTIONS
7
3. With the Extender Bracket (FF) installed , mark
the hardware hole location.
4. Remove the Extender Bracket (FF) and using
5/16" drill bit, pre-drill marked hole locations into
drywall. Then
install Drywall Anchor (AA) into
pre-drilled drywall holes.
Do not drill through the
metal bracket.
4
3
FF
AA
If you are unsure if a stud is located
behind markings, use 1/8" drill bit to
drill all holes. If no stud is present,
then use 5/16" drill bit to make holes
larger for drywall anchors.
PRO TIP
Use a rubber mallet to lightly tap
Drywall Anchors (AA) into the drywall.
PRO TIP
Hardware Used
x 1
AA
Drywall Anchor