Installation Instructions

Step 1
Dig holes for terminal post approx-
imately 8 in. in diameter and 18 in.
to 30 in. deep, with sides that
slope out toward bottom of hole
(Fig. 2). The depth will be deter-
mined by local codes / weather
zones.
Step 2
Mark the ground line on posts with
a marker or chalk. Post height,
above level ground, of terminal
posts will equal the height of the
fence fabric plus 2 in.
Step 3
Locate posts in center of holes.
Plumb posts and adjust height so
that your mark is at ground level.
Fill in hole with continuous pour of
concrete. Trowel the top so it
slopes away from the post for
water to run off.
Note:
Use 2-3/8 in. “terminal” post
anchor as an alternative to concrete.
Terminal
Post
Mark
Ground
Level
Chain Link
Fabric Height
2in.
18in.- 30in.
8in.
Fig. 2
Step 1
When the terminal post footings have hardened, stretch a string
taut between terminal posts, placing the string on the outside
face of the post and 4 in. down from the top of the post (Fig. 3).
Height of line posts should be 2 inches less than the chain link
fabric height, above the ground.
Step 2
Measure the distance between terminal
posts and refer to post spacing chart to
determine the distance between line posts.
Dig line post holes approximately 6 in. wide
and 18 in. to 24 in. deep, with sloping sides
(Fig. 4). The exact diameter and depth will
be determined by local codes / weather
zones. Plumb posts and make sure they are
on the center line of the terminal posts, and
top of post is level with string line. Fill in
holes with continuous pour of concrete.
Trowel the top so it slopes away from the
post for water to run off.
Note: Use 1-5/8 in. “line” post anchor as
an alternative to concrete.
Terminal
Post
Line Post Line Post
Terminal
Post
String
4in.
4in.
Fig. 3
Fig. 4
Line
Post
Fence
Fabric
Height
18in. - 24in.
2in.
6in.
2. Terminal Posts 3. Line Posts