User`s manual

b. Slide the HDD tray back into the N2200/N2200PLUS until it snaps into

place.

3. For 2.5” HDDs

c. Remove an HDD tray and install a 2.5” SATA hard disk onto it.

d. Slide the HDD tray back into the N2200 until it snaps into place.

Cable Connections

N0204:

To connect the N0204 miniNAS to your network, follow the steps below:

1. Connect an Ethernet cable from your network to the LAN port on the back

panel of the N0204 miniNAS.

2. Connect the provided power adaptor into

the power socket on the back panel. Plug

the other end of the cord into a surge

protector socket.

3. Press the Power button on the Rear end

to boot up or shut down the N0204 miniNAS.

NOTE

1. USB copy LED will be flashed Blue

light during the system are

booting and will be dull after the

booting complete.

2. To shut down the system, press

the power button over 4 seconds,

then USB copy LED

will be flashed

Red light, release power button.