User`s manual

Replacing Damaged Hard Drives
you can easily replace a damaged hard
ur data secure with the system’s
ard Drive Damage
ge also the system beeps.
3. Slide a new hard disk into the tray and fasten the screws.
e N4200 until it snaps into place. You
n when the HDD is accessed.
the system beeps and/or an email notification is sent
3. Follow the steps mentioned above to replace the failed hard disk.
4. The system automatically recognizes the new hard disk and starts the
If you are using RAID 1, RAID 5, or RAID 6
drive in the Thecus N4200 while keeping yo
automatic data recovery.
H
When a hard drive is damaged and data in the RAID volume, the system OLED will
display warning messa
Replacing a Hard Drive
To replace a hard disk drive in the N4200:
1. Remove the tray with the damaged hard disk.
2. Unscrew the damaged hard disk and remove it from the tray.
4. Insert the hard disk tray back into th
can also lock it with a key if desired.
5. The LED blinks gree
RAID Auto-Rebuild
When using RAID 1, 5, 6, or 10 on the N4200, you can use the auto-rebuild function
when an error is detected.
1. When a hard disk fails
to specified receivers.
2. Check the OLED to see which disk has failed.
auto-rebuild sequence to resume its status before the hard disk crash.
115