User`s manual

Chapter 2: Hardware Installation
Overview
Your N4200 is designed for easy installation. To help you get started, the following
chapter will help you quickly get your N4200 up and running. Please read it carefully
to prevent damaging your unit during installation.
Before You Begin
Before you begin, be sure to take the following precautions:
1. Read and understand the Safety Warnings outlined in the beginning of the
manual.
2. If possible, wear an anti-static wrist strap during installation to prevent static
discharge from damaging the sensitive electronic components on the N4200.
3. Be careful not to use magnetized screwdrivers around the N4200’s electronic
components.
Hard Disk Installation
The N4200 supports seven standard 3.5” Serial ATA (SATA) hard disks. To install a
hard disk into the N4200, follow the steps below:
1. Remove a hard disk tray from the N4200.
2. For 3.5” HDDs
a. Remove an HDD tray and install a 3.5” SATA hard disk onto it.
b. Slide the HDD tray back into the N4200 until it snaps into place.
3. For 2.5” HDDs
a. Remove an HDD tray and install a 2.5” SATA hard disk onto it.
b. Slide the HDD tray back into the N4200 until it snaps into place.
If your HDD was part of a RAID 1, RAID 5 or RAID 6 array previously, it
automatically rebuilds. If you replace all the drives with higher capacity
drives, you will need to go to Administrator login and format the drives.
NOTE
14