User`s manual

Chapter 3: First Time Setup

Overview

Once the hardware is installed, physically connected to your network, and powered

on, you can configure the N4200 so that it is accessible to your network users. There

are two ways to set up your N4200: using the Thecus Setup Wizard or the OLED

display. Follow the steps below for initial software setup.

Thecus Setup Wizard

The handy Thecus Setup Wizard makes configuring N4200 a snap. To configure the

N4200 using the Setup Wizard, perform the following steps:

1. Insert the installation CD into your CD-ROM drive (the host PC must be

connected to the network).

2. The Setup Wizard should launch automatically. If not, please browse your

CD-ROM drive and double click on Setup.exe.

NOTE

For MAC OS X users, double click on Thecus Setup Wizard .dmg file.

3. The Setup Wizard will start and automatically detect all Thecus storage

devices on your network. If none are found, please check your connection

and refer to Chapter 7: Troubleshooting for assistance.

4. Select the N4200 that you like to configure.

5. Login with the administrator account and password. The default account and

password are both “admin”.