User`s manual

The N4200 will rotate these messages every one-two seconds on the OLED display.

USB Copy

The USB Copy function enables you to copy files stored on USB devices such as USB

disks and digital cameras to the N4200 by press button. To use USB copy, follow the

steps below:

1. Plug your USB device into an available USB port on the Front end.

2. In Display Mode, press the Down Button (▼).

3. The OLED will display “USB Copy?”

4. Press Enter (

↵) and the N4200 will start copying USB disks connected to the

front USB port.

5. All of data will be copied into system folder named “USB copy”.

Management Mode

During setup and configuration, the OLED will be in Management Mode.

To enter into Management Mode, press Enter (

↵) and an “Enter Password” prompt

will show on the OLED.

At this time, the administrator has to enter the correct OLED password. System will

check whether the correct OLED password has been entered. The default OLED

password is “ 0000 ”. If correct password is entered, you will enter into the

Management Mode menu.

Management Mode

Item Description

WAN Setting IP address and netmask of your WAN ports.

LAN Setting IP address and netmask of your LAN ports.

Link Agg. Setting Select Load Balance, 802.3ad or Failover.

Change Admin Password Change administrator’s password for OLED operation.

Reset to Default Reset system to factory defaults.

Exit Exit Management Mode and return to Display Mode.

You can also change your OLED password using the Web Administration

Interface by navigating to System Management >Utility>

Administrator Password. For more on the Web Administration

Interface, see Chapter 4: System Management.

NOTE

Typical Setup Procedure

From the Web Administration Interface, you can begin to setup your N4200 for use

on your network. Setting up the N4200 typically follows the five steps outlined

below.

For more on how to use the Web Administration Interface, see

Chapter 4: Web Administration Interface.