Product Specs

OWMH-DS6311-01 Product Specification
Version:0.1
Date: 2018.11.14
Page 8 of 8
7. Memory configuration
Depending on customer's request, the module can be shipped with following configuration:
Flash size: 8MB, 16MB NOR Flash
DDR2 size: 64MB, 128MB
8. Mechanical Application Notes
1. CON0 and CON1 are IPEX1 connectors on top side
2. J1 is 2*23 pins 1.27mm female header on bottom side for signals
3. J2 is 2*10 pins 1.27mm female header on bottom side for signals
4. The mechanical drawing in .dxf format is available under request.
9.Professional installation instruction
1. Installation personal
This product is designed for specific application and needs to be installed by a qualified
personal who has RF and related rule knowledge. The general user shall not attempt to
install or change.
2. Installation location
The product shall be installed at a location where the radiating antenna can be kept 20cm
from nearby person in normal operation condition to meet regulatory RF exposure
requirement.
3. External antenna
Use only the antennas which have been approved by the applicant. The non-approved
antenna(s) may produce unwanted spurious or excessive RF transmitting power which
may lead to the violation of FCC Part15C/E & Canada limit and is prohibited.
10.Compliance
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Device cannot be sold via retail to the general public or by mail order; it must be sold to authorized dealers or installers
only.