User's Manual

5 INSTRUCTION MANUAL

FCC RF

INTERFERENCE STATEMENT

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation.

This equipment generates, uses and can radiate radio frequency energy and,

if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no guarantee

that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television

reception which can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one or more of the following

measures.

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

- Consult the dealer or an experienced radio, TV technician for help.

- Only shielded interface cable should be used.

Finally, any changes or modifications to the equipment by the user not

expressly approved by the grantee or manufacturer could void the users

authority to operate such equipment.

DOC COMPLIANCE NOTICE

This digital apparatus does not exceed the Class B limits for radio noise emissions

from digital apparatus set out in the radio interference regulation of Canadian

Department of Communications.

AVIS DE CONFORMATION AU MDC(DOC)

Le présent appareil numérique n´émet pas de bruits radio-électriques dépassant les

limites appliqués aux appareils numériques de Class B d´après les règlements sur

le brouillage radio-électrique conçuent par le ministère des communications du

Canada.