User's Manual

84
Problems and troubleshooting / Video head cleaning
Video head cleaning
Video head clogging
The video heads are the means by which the DVD/VCR reads
the picture from the tape during playback. In the unlikely event
that the heads become dirty enough to be clogged, no picture
will be played back. This can easily be determined if, during
playback of a known good tape, there is good sound, but no
picture (picture is extremely snowy). If this is the case, have the
DVD/VCR checked by qualified service personnel.
NOTES: DO NOT ATTEMPT TO CLEAN THE VIDEO HEADS OR SERVICE THE UNIT BY REMOVING THE
REAR COVER.
Video heads may eventually wear out and should be replaced when they fail to produce clear pictures.
To help prevent video head clogging, use only good quality VHS tapes. Discard worn out tapes.
SYMPTOMS POSSIBLE SOLUTIONS PAGE
No picture, or the screen is blurred
or divided into two parts.
No 4:3 (16:9) picture
No on-screen display
No surround sound
The unit or remote operation key is
not functioning.
Playback does not start when the
title is selected.
Audio soundtrack and/or subtitle
language is not changed when you
play back a DVD.
No subtitle
Angle cannot be changed.
appears on the screen.
The S-VIDEO/COMPONENT selecter is not set correctly.
The progressive scanning mode is active through the unit is
connected to a TV via the VIDEO OUT jack.
The setup does not match your TV.
Select Display On.
The setup does not match your stereo system.
Turn off the unit and unplug the AC power cord for several min-
utes, then replug it.
Check the Parental setup.
Multilingual language is not recorded on the DVD disc.
Some discs have no subtitles.
Subtitles are cleared. Press SUB TITLE.
Multi-angles are not recorded on the DVD disc.
The function is prohibited with the unit or the disc.
16
52
49
50
17
44
47,48
42,47
43
Snowy PictureGood Picture
VRDVD4005_P69-P86 03.8.20, 11:28 PM84