INSTRUCTION M ANUAL IRON Model: ORI-025 ENGLISH GB http://www.orion.
Dear Customers, Thank you for buying ORION products! Welcome to use! Read the instructions for use carefully before using the appliance and save them for future reference. IMPORTANT SAFEGUARDS 1. Before connecting the appliance check that the voltage indicated on the type plate corresponds to the mains voltage in your country. 2.
DETAILS 1. Spray nozzle 2. Water inlet cover 3. Steam control knob 4. Spray button 5. Burst steam button 6. Pilot light cover 7. Cord sleeve 8. Beaker 9. Temperature control knob 10. Self clean button 11. Water tank 12. Soleplate HOW TO USE Note: Remove any labels, stickers or protective foil that may be attached to the body or soleplate of the iron before first use. The iron may give off some smoke and emit an odor when you first use. This will cease after a short while.
Setting the temperature Fabric NYLON/ACRYLIC/ACETATE Temperature control SILK/RAYON/POLYESTER WOOL/COTTON LINEN MAX 1. Stand the iron on its heel and plug the power cord into wall socket. 2. Turn the iron temperature control knob until you get the desired fabric/temperature setting. We recommend using the above table as a guide. 3. The temperature pilot light will light, indicating that the soleplate is heating up. 4. When the pilot light goes out, the required temperature has been reached.
Note: Only use the steam push button when the steam iron has reached the steam or maximum temperature. Do not press this burst steam button more than 3 times at once. For optimal steam output, leave an interval of at least four seconds between pressing the burst steam button. The burst steam feature can be used with Dry or Steam ironing as desired. Never direct the steam towards people and animals. Burns or serious injury may occur. Vertical shot of steam 1. Hang your clothes on a hanger 2.
To let the iron heat up again: 1. Pick up the iron or move it slightly. 2. The auto-off pilot light stop flashing (or the buzzer will stop beeping). if the temperature of the soleplate has dropped below the set ironing temperature, the temperature pilot light will turn on. 3. If the temperature pilot light truns on after you have moved the iron, waiting until it goes out before you start ironing.
