User Manual

6 Warning Situation: When the Monitor run out of
initial setting up by factory default.
Warning Method: The four display unit will show by
E1 and not lighting on four tires figures.
7 Warning Situation: When Monitor sensor can not
receive one of the tire sensor, over than 9 min..
Warning Method: The failure tire sensor will show
by E2 without light on tire figure.
8 Warning Situation: When the tire sensor got failure
on factory default.
Warning Method: The monitor will show by E3 on
the failure tire sensor without tire light figure.
NOTE: The user can press the MODE button continuously for 3 sec. to stop the warning sound.
W401 Reset for Tire Changing and Rotation
When the user are doing/finished the changing or rotating the tires, should also reset
the monitors ID’s position, however, ORO TEK TPMS provides 4 modes in order to
make the user can reset rapidly and keep the tire position as same as shows by the monitor.
Set Up Process for Enter the Tire Changing and Rotation
Press the Set Up and Mode button simultaneously for 3 sec., the system will enter set up mode 1, mode
2, mode 3, mode 4 and turn back to the normal monitoring display by pressing once a time.