User Manual

1. Set up for RF tire sensor:
The display will flash green and red with No. 1 which means the RF tire can be proceed for the
set up as below pic. 1, by the meantime the user should deflate the tire pressure rapidly over
than 0.3bar/30kPa or 4 Psi in 15 sec. until sounds Beep, which means the user is completed
the set up for RF tire as shows on below pic. 2. If there is no need to set up the RF tire sensor,
just press the Set Up mode button to jump over this process.
Pic 1 Pic 2
2. Set up for RR tire Sensor.
The display will flash green and red in tire figure and No. 2 which means the RR tire can be
proceed for the set up as below pic. 1, by the meantime the user should deflate the tire
pressure rapidly over than 0.3bar/30kPa or 4 Psi in 15 sec. until sounds Beep, which means
the user is completed the set up for RR tire as shows on below pic. 2. then the systems will
enter to the LR tire sensor set up mode.
Pic 1 Pic 2
3. Set up for LR tire sensor.
The display will flash green and red in tire figure and No. 3 which means the LR tire can be
proceed for the set up as below pic. 1, by the meantime the user should deflate the tire
pressure rapidly over than 0.3bar/30kPa or 4 Psi in 15 sec. until sounds Beep, which means
the user is completed the set up for LR tire as shows on below pic. 2. then the systems will
enter to the LF tire sensor set up mode.