User Manual

Pic 1 Pic 2
4. Set up for LF tire sensor
The display will flash green and red in tire figure and No. 4 which means the LF tire can be
proceed for the set up as below pic. 1, by the meantime the user should deflate the tire
pressure rapidly over than 0.3bar/30kPa or 4 Psi in 15 sec. until sounds Beep, which means
the user is completed the set up for LF tire as shows on below pic. . then the systems will enter
back to the normal operating display.
Pic 1
Mode 5 Single sensor replaced
The monitor will display No. 3 in yellow which means Mode 5.
The user should reset from Right Front Tire -> Right Rear Tire -> Left Rear Tire -> Left Front Tire in
order to complete the set up mode 5 and back to the normal operating mode.
1. Set up for Right Front Tire sensor:
The display will flash green and red with No. 1 which means the RF tire can be proceed for the
set up as below pic. 1, by the meantime the user should deflate the tire pressure rapidly over
than 0.3bar/30kPa or 4 Psi in 15 sec. until sounds Beep, which means the user is completed
the set up for RF tire as shows on below pic. 2. If there is no need to set up the RF tire sensor,
just press the Set Up mode button to jump over this process.