User Manual

Pic 1 Pic 2
2. Set up for RR tire sensor
The display will flash green and red in tire figure and No. 2 which means the RR tire can be
proceed for the set up as below pic. 1, by the meantime the user should deflate the tire
pressure rapidly over than 0.3bar/30kPa or 4 Psi in 15 sec. until sounds Beep, which means
the user is completed the set up for RR tire as shows on below pic. 2. then the systems will
enter to the LR tire sensor set up mode.
Pic 1 Pic 2
3. Set up for LR tire sensor.
The display will flash green and red in tire figure and No. 3 which means the LR tire can be
proceed for the set up as below pic. 1, by the meantime the user should deflate the tire
pressure rapidly over than 0.3bar/30kPa or 4 Psi in 15 sec. until sounds Beep, which means
the user is completed the set up for LR tire as shows on below pic. 2. then the systems will
enter to the LF tire sensor set up mode.