User Manual

Pic 1 Pic 2
4. Set up for LF tire sensor
The display will flash green and red in tire figure and No. 4 which means the LF tire can be
proceed for the set up as below pic. 1, by the meantime the user should deflate the tire
pressure rapidly over than 0.3bar/30kPa or 4 Psi in 15 sec. until sounds Beep, which means
the user is completed the set up for LF tire as shows on below pic. . then the systems will enter
back to the normal operating display, without any changing.
Pic 1
Warning
The user should be secure that the monitor should be plug in to the power, when is processing the tire
changing/rotating mode, if the power is interrupt, just follow the reset process in order to proceed
successfully. The user should confirm whether the display can monitor all the tire information correctly,
if not, just follow the reset process.
The user should confirm whether the all sensors are manufactured by ORO TEK before do any
changing or replacement,, if not, the user won’t be able be succeed on set up neither make the system
operating normally.
ORO-TEK Warranty Policy
We warrant our products for one year (365 days) from the date of original purchase to be free
from defects in materials and workmanship. If, during this period, the product fails under
normal usage, because of a manufacturing defect, we will replace or repair the item. To obtain
repair or replacement under the terms of this warranty, please return the product to the place
of purchase. Proof of purchase and date of purchase are required to validate the warranty
claim. If cannot proof the warranty will be just 2 months. For ex: (2009/1, the warranty period is
until 2009/3)