User Manual

c Put the marked No. 1 tire sensor to the tire which market
No. 1. as step a. photo and follow steps:
1. Install the tire sensor to the valve.
2. Use the nylok screw and tight up with the tire sensor.
(Pls. use the screwdriver which is included to the
accessories bag)
3. Adjust the tire sensor’s angle (paste on the surface of
the wheel), then tight up the with the nylok screw.
4. Put on the valve’s cap, and finish the installation.
When there is necessary to re-install the tire sensor, pls.
use the new nylok screw in order to prevent to re-use the
old ones.
d Put on the No. 2 tire sensor to the tire which marked
No.2, and set up the other 2 sensor in the same manner as
shows in the step c.
e Make sure there is no other liquid or dust beside of the
tire sensor.
f Follow the tire specification and inflate appropriate air to
the tire after finished the installation.
g
Balance the tires with the balance machine。
h Put back the tires to it’s corresponding position as shows
in the photograph on step a.
Turn on the ignition after the TPMS installation and start to monitoring the tire pressure/temperature
and car battery.