Install Manual

INSTALLATION INSTRUCTIONS
Tire Pressure Monitor System (TPMS) Sensor Assemblies
WARNING
Read all instructions and warnings before installation. Refer
to Mitchell Manual for installation specifications (excluding
Ford Banded Sensors). Professional installation only. These
Tire Pressure Monitor System Sensor assemblies are
replacement or maintenance parts for motor vehicles that
have a factory installed Tire Pressure Monitoring System
(TPMS).
Caution
Each TPMS sensor is designed and manufactured to operate in a
specific motor vehicle year, make and model, using the proper
frequencies to communicate with the motor vehicle TPMS system.
Only install TPMS sensors designated for your specific motor vehicle
year, make, and model. Improper installation will cause the motor
vehicle TPMS system to fail to operate properly.
Do not install sensors in damaged wheels. Upon completion of
installation, test the motor vehicle TPMS system using procedures
described in Mitchell1 Manual (excluding Ford Banded Sensors) to
confirm proper installation. If the TPMS system fails to operate
properly, check all installation procedures to ensure proper
installation and retest. If the TPMS system continues to fail to
operate, immediately consult with an authorized motor vehicle
dealership.
If the OEM equipment wheels or tires are not used it is the
responsibility of the vehicle owner to ensure that the TPMS system is
functioning properly. The vehicle owner expressly assumes sole and
complete responsibility for the TPMS and vehicle function if the OEM
equipment wheels and tires are not used. Failure to ensure that the
TPMS system is functioning properly can result in severe injury or
death.
It is MANDATORY to replace the sensor if it is externally damaged.
WARNING FAILURE TO FOLLOW INSTRUCTIONS OR THE USE OF IMPORPER
TPMS SENSORS MAY RESULT IN THE MOTOR VEHCILE TPMS FAILURE
CAUSING POPERTY DAMDAGE PERSONAL INJURY OR DEATH.