翔鑫科技股份有限公司 Oro Technology Co.
ORO WT01 TPMS Manual To ensure correct operations and services please read these instructions before installing and operating the TPMS NOTICE This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
ORO WT01 TPMS ORO-WT01 Tire Pressure Monitoring Systems (TPMS), can monitor and provide tire pressure, tire temperature and car battery information in real time to help the driver control and keep the normal tire pressure in order to reduce the fuel consumption and extend the tire life, and also through the battery information, the driver can change the battery before any incident occurs and reduce the possibility of vehicle breakdown on the roads.
WT01 TPMS Accessories Accessories QTY Accessories QTY Display 1 Battery 11 Power Cable 1 Tire Sensor 11 Antenna 1 Lock-Nut 11 Antenna Holder 1 Spanner 1 1 Manual 1 Adjustable Multi Angle Holder Cable tie 10 3
WT01 TPMS Installation 1. Tire Sensor Installation Step a Operation Process Photographs Take off the 11 tires and mark 1~11 for each tire position. b Install CR1632 Battery into Tire Sensor。 c Insert the Lock-Nut into the valve. Tighten the Tire Sensor and use the d spanner to lock the Lock-Nut back to the Tire Sensor and complete the installation. ※This product is recommended with metal valve or replace the original valve regularly to ensure better quality.
2. Display Installation New adjustable multi angle holder (STANDING TYPE) assemble manual: New adjustable multi angle holder (PASTE TYPE) assemble manual: 3M adhesive Upon decided where to paste, tear out 3M adhesive from the base and stick on the holder.
a. Firmly secure the magnetic holder in a suitable place. (Suggested place as shown in the picture) b. Put the display on the magnetic holder. c. Keep 20cm of distance from GPS; digital TV; speed measure device or other automotive electronic devices while are installing TPMS in order to prevent any possible of interference. d. Please solder the red cable to the AC power, the black cable is for grounding.
