User's Manual
14
6.8.2 Re-fitting into enclosure
• Offer G4 into backplate with switches facing outwards.
• Engage base of G4 into D shaped metal prongs.
• Antenna rests either to left or right of release pin.
• Check G4 is fully engaged in metal prongs and resting on foam pad.
• Refit cover by first locating release pin through hole in cover.
• Locate cover onto backplate, then snap down over locating lug.
• Refit R-clip through hole in end of release pin.
3
Fit cover
over pin
4
Snap cover onto
locating lug
5
Fit R-clip
through pin
1
2
Switches
facing
out
Fit D-shaped
foot into prongs
CAUTION
Failure to fit EPIRB
correctly may impair
its ability to float free
in an emergency