Manualshelf

User's Manual

ManualsBrandsOrolia ManualsElectronicsMcMurdo Smartfind E5, Kannad Marine Automatic EPIRB, Kannad Marine Manual EPIRB, Sailor SE406-II, Simrad EP50
31323334353637383940
Page 31
10.2 Mechanical inspection
During these monthly checks you should take the opportunity to inspect the EPIRB
and its mountings visually for deterioration or damage.
Note that the EPIRB is designed to allow water to circulate around the outer edge of
the dome (inside the outer clear plastic edge but outside the waterproof seal),
consequently a volume of water in this area is of no consequence.
On the EPIRB itself check the following:
• Inspect the EPIRB for any obvious damage
• Check that the lanyard is not tied to the vessel structure
• Check the battery is within its expiry date
• Check that the sea switches are clean and free from paint or grease
• Check that the antenna has not been creased, so that it erects to a near-
vertical position when released.
If during these checks it is discovered that the frangible seal has been broken, then
the EPIRB may have been activated. The battery condition is thus suspect, and the
battery should be replaced at the earliest possible opportunity. It is, however, possible
to verify the condition of the battery to a limited extent by using the indication of the
self-test, as described in section 10.1.1. If the LEDs flash more than once, then there
is a good chance that the battery will provide the specified performance. IT IS
RECOMMENDED THAT THE BATTERY IS REPLACED REGARDLESS OF SUCH
VERIFICATION.
If you have a bulkhead bracket:
• Check the EPIRB is correctly fitted and secure in its bracket
• Check that the two halves of the bracket are securely connected
If you have an enclosure:
• Check the HRU is within its expiry date
• Confirm the cover can be easily removed
• Ensure the EPIRB base is correctly fitted into the D-shaped recess and
that the antenna is correctly stowed
If the EPIRB or its mounting needs cleaning then this should be done using warm
soapy water and a damp (not wet) cloth. Do not use strong detergents or solvents.
Do not paint the EPIRB or its mounting
Do not clean with detergents or solvents
During vessel cleansing or painting remove the EPIRB and its mounting.