User's Manual

Page 10
Self-test of the AIS SART
It is recommended to self-test the AIS SART annually; more frequent self-testing can put
unnecessary drain on the battery. When self-testing, a specially coded AIS test transmission
is sent that will be visible to all AIS users in the locality. As a successful self-test result is
dependant on a valid GPS acquisition; testing must be carried out in the open and under an
unobstructed sky.
Self test procedure
Remove the AIS SART from its stowage case and assemble the top section onto the
mounting pole. It is not necessary to fully extend the mounting pole. Take the AIS SART
outside and hold it aloft under a clear view of the sky; this will then maximise the speed of
the GPS position fix. Proceed as follows:-
1. Push and hold the TEST button down until the red LED lights.
2. The red LED will flash quickly indicating that the self test routine is in progress.
3. The maximum self-test duration is five minutes (typically 1min)
4. A successful self-test will result in the red LED signalling 3 long flashes.
5. Once the self-test has completed the AIS SART will switch off automatically.
A self-test failure will result in no pass indication from the red LED. In this unlikely event, it is
recommended to further improve the sky view and to repeat the self-test procedure.
Important
Unnecessary self testing of the AIS SART can reduce the overall run time available in an
emergency. Each self test draws a small amount of energy from the battery.
If the AIS SART has been activated for a cumulative period in excess of 6 hours (self-test
and operation), then the battery must be replaced to ensure that in an emergency it will still
operate for a minimum of 96 hours at -20 °C as required by International Regulations.
An AIS SART that fails self-test should be immediately removed from service; refer to the
maintenance section for further information.
Self test button
Press and hold for 2 seconds to start the
self-test routine.
RED LED indicates self test in progress.