Installation Manual

Section 4 Installation
4.1. General
This section provides instructions for installing the TR500. While the guidelines deal primarily with the
requirements for mounting onto a fuel pump-head, the steps are applicable to any type of cabinet.
4.2. Installation Procedures
This section provides instructions for installing the TR500 on a new pump or cabinet in three different
ways:
On the door / front of the pump
On top of the pump
On the wall near the pump
Strictly observe all the safety instructions detailed in Precautions and Safety Information.
4.2.1. Installation on Door/Front of Pump
4.2.1.1. Drilling Template
When installing on the door/front of a pump, the following drilling template will be provided (see Figure
4-1):
Figure 4-1 - Drilling Template
Use this template to determine hole places when drilling on the surface where you plan to install the
TR500.
TR500 Installation and Setup Manual 21