User's Manual

6 DP Replacement Technical Bulletin
5. µDATAPASS PINOUT
Table 3 details the µDataPass connector pinout
Table 3. µDataPass Pinout
Pin #
Pin Name
Description
16
VIN+
Supplied voltage (+)
4
VIN-
Supplied voltage (-)
7
K-line (ISO)
Utilized for K- line protocol
6
CAN H
For Can Bus protocol, connect to
'CAN H' in the vehicle bus
14
CAN L
For Can Bus protocol, connect to
'CAN L' in the vehicle bus
6. INSTALLATION PROCEDURE
µDataPass installation is a very simple process. However, since µDataPass is a very small
device, it is recommended to fasten the unit to the vehicle using a nylon thread or a
similar fastener to prevent loss if removed from the OBD II connector during vehicle
servicing.
Proceed as follows:
1. Locate the standard On Board Diagnostics OBD-II connector (see Figure 2).
This connector is normally located under the dash on the left side of the
steering column. Remove the panel that covers the Diagnostics connector
Figure 2. Diagnostics Connector
2. Gently plug the µDataPass into the Diagnostics connector being careful not to
bend the µDataPass pins (see Figure 3)