Installation & Assembly

1, WALL SURFACE PREPARATION
All the basic wall surface must be flat, dry,
clean, and firm. Aged wall surface must be
painted with water-based seal primer to fix
the loosen surface
2, PREPARATION FOR THE COMMODITIY
Open the box, put the panels on the floor for 24
hours to balance the moisture between panels and
environment, to prevent excessive expansion or
contraction after installation(Remark: put 5pcs in
one stack, take out the panels carefully and gently)
3, MEASURE THE WALL AND PLAN
THE DESIGN
Measure the size of wall to find out the
central point of it, then mark vertically and
horizontally. Arrange it on the floor by
rotating the panels before attempting to
install, ensuring correct installation of the
desired pattern
4, INSTALL THE PAENLS ON THE WALL
Put the heavy duty construction adhesive to the lower parts of panel back, to put the adhesive higher than
the panel back. Apply the panels on the wall same as planned design, pressing the panels' edges to ensure
all the panels adjoin the wall tightly, it will be better to set aside it two hours for drying, then move to the
next step.
5, Cutting Panels
Using wallpaper knife or electric saw to cut panels freely when meet corner or electric outlet of the wall