Installation Instruction

Ⅱ Installation Steps

1. Measure the wall and plan the design.

2. Adhere with All-purpose adhesive glue (

Titebond made in USA recommended)

5) Use the wallpaper (knife) or sandpaper to

clean the gaps to ensure all the gaps are smooth

and neat

1) Measure and mark horizontally and vertically the area

of installation

2) Select a pattern for installation. Arrange it on the floor

by rotating the panels before attempting to install

ensuring correct installation of the desired pattern.

3) If the area for installation is not square, or just meet

the connection of the circuit, the panels can be cutted by

knife

1) Use the all-purpose adhesive glue to dot on

the board every 30 to 50 mms on the flat surface,

Especially on the edges of the boards, the point

of the glue must be 5mm inside against the edge

in order to avoid the glue overfolw.

2) After dot the glue on the

oards, put it on the wall

and take it out asap. This method is only used for the

glue (Titebond). For other kinds or brand of glue,

please follow the instruction indicated in the glue

packaging

3) Keep gaps of 1.5mm between different boards

for future adjustment if there is distortion of

boards caused by room humidity. It’s better to use

the tile cross

4) Press the panel to ensure all its corners and edges

adjoin the surface, avoid strong pressure on the relif

parts.It will be better set aside one hour for drying,

then move to the next step.

Installation Instruction