Assembly Instructions

Step 3
Place the chair on a LEVEL SURFACE to check for wobbles.If it wobbles, lift the chair some 20cm to 30cm
high from the ground.Keep your feet and toes well awayfrom the drop zone.Drop the chair freely and
vertically with all four legs, hitting the ground, at the sametime.This Drop Test will help to ensure that all the
Bolts and gaps reach full alignment status.Test again for evenness on a LEVEL SURFACE.If no wobbles are
found, slowly and steadily, place the chair facedown.Then, proceed to tighten all Bolts in a sequential
manner.When tightening the Bolts, tighten sequentially.DO NOT tighten any Bolt fully and then move on
towards the next one.This could cause the frame to warp. If there are still wobbles, loosen the Bolts and
execute the same drop test.If the chair is not stable, it could lead to damage to the product.
Step 2
Lay the Chair(A) on a clean, non-marring surface.
Attach Legs(B) to Chair(A) using Bolts(①) with Allen Key(②) as pictured above.
Keep the Bolts slightly loosen.And then turn to Step 2 for leveling.
Note: The front side of the Leg is at a right-angle and back side of the Leg is an oblique-angle.
Your Modern Chair is ready for use.
This Modern Chair can only be used on a flat, level surface.
Drop Test
If wobble
Test again
20～30CM
Page 4 OF 5