Installation & Assembly

Assembl
y
|
Armad
o
|
Assembla
g
e
Assembl
y
|
Asamblea
|
Assembla
g
e
6 |
English
Note! Installation by a certified electrician is recommended.
• Find your main fuse or breaker box in
your home.
• Turn off and/or unscrew all fuses.
• Turn off all circuit breaker switches
that control power to the room in
which you are working.
• Turn any wall switches off. If any pull
chains or switches are on the fixture,
turn off.
Note! Do not damage any wire insulation
during installation. Ensure no rough or
sharp edges are in contact with any wires.
Mounting Instructions:
1. Confirm power is off.
2. Remove the screws(5) from the
lamp body(C) and take mounting bracket(B) down from lamp body(C).
3. Drill two holes at the proper location on the wall related with the hole of mounting bracket(B).
4. Tap the anchors(1) into the two holes using a hammer.
5. Attach the mounting bracket(B) to the wall and fasten the screws(2) into two holes.
6. Screws(3) into the mounting bracket(B) and fasten the screws(3) into an electrical box(A).
Make the wire connections:
1. Confirm power is off.
2. Connect the electrical box black wire to the black fixture wire with connector (4).
3. Connect the electrical box white wire to the white fixture wire with connector (4).
4. Connect the green/yellow grounding wire to the copper fixture wire with connector (4).
Attach the lamp:
1. Remove the screws(6) from lamp body(C).
2. Slide the shade(D) in the lamp body(C).
3. Attach the part(E) to lamp body(C) with screws(6).
4. Attach lamp body(C) to the mounting bracket(B) with the screws(5).