Installation Instructions

INSTALLATION INSTRUCTION FOR FIXTURE
MOUNTING THE FIXTURE (FIG. 1)
Warning:
Read instructions carefully. If you are unclear as to
how to proceed, consult a qualified electrician.
NOTE: Proper wiring is essential for the safe
operation of this fixture.
1. Shut off the power supply at the fuse box or circuit
breaker. If necessary, remove the old fixture from wall.
Including the mounting hardware.
2. Carefully remove the new fixture from the carton and
check that all parts are included as shown in the
illustration.
3. Attach the mounting plate (L) to the outlet box using
the outlet box screws (J). The side of the mounting
plate marked “GND” must face out.
4. Attach the fixture wall plate (I) over the mounting plate
(L) and secure them by 2 mounting screws (H) snugly.
5. Place the glass Plate (F) between the steel
plates(K) ,then secure lock balls (M) tightly.
6. Install the bulb in accordance with fixture’s
specifications. (DO NOT EXCEED THE MAXIMUM
WATTAGE RATING NE PAS DEPASSER LA
PUISSANCE NOMINALE MAXIMALE!)
CONNECTING THE WIRES (FIG. 2)
1. At this point, connect the electrical wires as shown in
Fig. 2, making sure that all wire connectors are
secured. If your outlet box has a ground wire (green or
bare copper), connect the fixture’s ground wire to it.
Otherwise, connect the fixture’s ground wire directly to
the mounting strap using the green screw provided.
2. Tuck the wire connections neatly into the wall outlet
box.
Your installation is now complete. Return power to the
junction box and test the fixture.
Fig.2
Fig.1
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.