Installation Instructions

1
Installation Instructions for
Temporarily install the mounting plate to the junction box.
Mark the anchor hole locations on the mounting plate and remove the mounting plate.
Drill appropriate size holes at the marked locations and install the anchors.
Secure the mounting plate to the junction box.
Screw the anchor screws into the anchors.
Install the brackets to the diffuser and secure them from inside the diffuser using the bracket screws, metal washers, and rubber
washers (in that order).
Install the diffuser to the backplate and secure them together using the thumb screws and washers.
Connect the fixture ground wire to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Mount the fixture base onto the mounting plate and secure it with the set screw using an Allen wrench.
1
2
3
1A
4
5
Wall
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliantNEC
junction boxes.
JUNCTION BOX
MOUNTING
PLATE
9
10
ALLEN KEY
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
11
6
7
SET SCREW
DIFFUSER
FIXTURE
BACKPLATE
ANCHOR
ANCHOR
SCREW
THUMB SCREW
AND WASHER
8
9
10
3 5
7
BRACKET SCREW
AND WASHERS
BRACKET
7
6
6
11
Wall (LED)
This product is safety listed for damp locations.