Installation & Assembly

Please consult your electrician for hanging fixture and wiring.

PRODUCTS ARE NOT INTENDED

FOR COMMERCIAL USE.

Page 1 of (2)

The fixture is designed to dim with a standard Triac

forward phase dimmer. Dimming levels will vary by

dimmer.

Due to inrush current wattage should not exceed 150

watts of product for a 600 watt dimmer.

Warning!This fixture is supplied with an

installed LED driver. Wires MUST be

connected to driver found in canopy and NOT

DIRECTLY TO POWER SOURCE or a short

might occur.

Installation & Assembly

PAGE 1
Installation & Assembly Please consult your electrician for hanging fixture and wiring. The fixture is designed to dim with a standard Triac forward phase dimmer. Dimming levels will vary by dimmer. Due to inrush current wattage should not exceed 150 watts of product for a 600 watt dimmer. PRODUCTS ARE NOT INTENDED FOR COMMERCIAL USE. Warning!This fixture is supplied with an installed LED driver. Wires MUST be connected to driver found in canopy and NOT DIRECTLY TO POWER SOURCE or a short might occur.
PAGE 2
IMPORTANT: Turn off the power at the main fuse or circuit breaker box before starting installation (A) Mounting Bracket (B) Anchors (D) Screw Locate all hardware & components before discarding packaging (A) 1.) (B) Step.1: Remove mounting bracket (A) from fixture and install to electrical box. (A) (C) (C) 2.) Step.2: Wire fixture to wires (C) in outlet box. Copper wire is for Ground. (B) 3.) (D) (D) Step.3: Adjust wire length to desired mounting height, and tighten strain relief screws to secure.