Manualshelf

Assembly and Installation Instructions

ManualsBrandsOrren Ellis ManualsCeiling LightsLethe 1 - Light Simple Circle LED Flush Mount
12
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Green Grounding
Screw (E)
Dry Wall
Screw (F)
Anchor (G)
Set
Screw(D)
Mounting Screw (B)
Wire Nut (C)
Mounting Plate (A)
Turn off the power at fuse or circuit
box.
2. Pull out the outlet wires and the house grounding wire
from the outlet box. Make wire connections using the
wire nuts:
---The black (hot) wire from the fixture to the black (hot)
wire from the power source.
---The white (neutral) wire from the fixture to the white
(neutral) wire from the power source.
---Attach the fixture grounding wire to the mounting plate
with the green grounding screw. Then connect it to the
house grounding wire with the wire nuts.
Carefully put the wires back into the outlet box.
4. Attach ceiling pan to mounting plate and tighten it with set screws.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
Ceiling Pan
House Grounding Wire
Outlet Box
Wire Nut (C)
Mounting Plate (A)
Dry Wall Screw (F)
Anchor (G)
Green Grounding Screw (E)
Mounting Screw (B)
Fixture Grounding Wire
Set Screw (D)
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
Hardware Package (inculded):
Turn off the power at fuse or circuit
box.
Installation Steps
1. Unscrew the set screws to remove mounting plate from
ceiling pan.
Warning: LED electronics can be damaged by electro static discharge (ESD)shock. Before
installation, discharge yourself by touching a grounded bare metal surface to remove this
hazard. To avoid damage, do not touch the LED module.
3.Attach the mounting plate to the wall.
a) If the wall material is wood:
Attach the mounting plate to the outlet box by
using two mounting screws, then secure the dry wall
screws through the set holes to the wall.
b) If the wall material is cement:
Place the mounting plate to the outlet box and mark the target on the wall from the set hole for
drilling two holes. Remove the mounting plate. Drill the holes and thread the anchors into the holes,
then attach the mounting plate to the outlet box by using two mounting screws. Secure the dry wall
screws through the set holes into the anchors.

Summary of content (2 pages)